Disable or re-enable your Clip 4Updated an hour ago
Disable your Clip 4 when you need to temporarily stop it from sharing its location. You can re-enable it at any time.
Important: Disabling your Clip 4 does not factory reset it or remove it from Apple Find My, Google’s Find Hub, or the Pebblebee app. If you are transferring the device, remove it from every connected app and complete a factory reset.
Before you begin
Charge your Clip 4.
Locate the button near the center of the Pebblebee logo.
Keep the device nearby so you can hear its confirmation sounds.
Disable your Clip 4
Press the button twice.
At the same pace, press the button a third time and hold it for approximately 10 seconds.
Listen for two beeps.
Release the button during the second beep, before it finishes.
Listen for the confirmation sound.
Your Clip 4 is now disabled and will stop sharing or updating its location.
If your Clip 4 does not disable
Make sure there is no pause between the first two presses and the third press-and-hold.
Release the button while the second beep is still playing.
Press the button firmly and use a steady rhythm.
Charge the Clip 4, then try again.
Re-enable your Clip 4
Press the button once.
Listen for the confirmation sound.
Your Clip 4 is now enabled and can resume sharing its location through its connected tracking network.